|
| |
TM 10-4930-240-13
4-20. SKID ASSEMBLY (TYPICAL) REPAIR.
NOTE
The following procedure applies to both fuel manifold and pressure reducing skids.
This task consists of
a. Disassembly
b. Cleaning
c. Repair
d. Assembly
INITIAL SET-UP:
Tools:
Material/Parts:
General Mech Tool Kit (App B, Sect III, Item 1)
Cleaning Solvent
(Item 1, App E)
Pipe Wrench (2 ea) (App B, Sect III, Item 5)
Wiping Rag
(Item 2, App E)
Equipment Condition:
Pressure reducing assembly removed (para 4-18)
NOTE
Ensure that all parts identified as mandatory replacement parts are discarded
and replaced with new components.
a.
Disassembly. Refer to figure 4-13.
(1) Remove ring (1) from insert (2).
(2) Remove insert (2) from skid (3).
(3) Repeat steps (1) and (2) for other end of skid (3).
b.
Cleaning.
WARNING
Dry cleaning solvent, P-D-680, Type III, is potentially dangerous to
personnel and equipment. Eye and skin protection is required. Avoid
repeated and prolonged skin contact. Wash hands immediately after
exposure. Do not use near open flame or excessive heat. Use only in areas
with good ventilation.
Using wiping rags and cleaning solvent, remove dirt and contaminants from all components.
c.
Repair. Replace damaged or defective components.
4-38
|
