|
| |
TM 10-4930-240-13
4-13. WYE ASSEMBLY REPAIR - cont.
d. Assembly. Refer to figure 4-4.
CAUTIONS
To prevent premature failure of wye assembly, gaskets certified for arctic
service must be installed. If a new wye body or dust caps has been installed,
remove and discard black gaskets supplied with the new components and
replace them with blue colored arctic service gaskets.
Ensure gaskets are fully seated in groove of coupling/dust caps to prevent
leaks In assembled components.
(1) Install gasket (13) in dust cap (14).
(2) Install dust cap (14) on body (15).
(3) Install gasket (12) in female coupling on body (15).
(4) Install dust plug (11) on body (15).
(5) Install gasket (10) on dust cap (9).
(6) Install dust cap (9) on body (15).
(7) Connect split ring (8), chain (6) and split ring (7).
(8) Connect split ring (5), chain (3) and split ring (4).
(9) Connect split ring (5), chain (1) and split ring (2).
4-14. DISCHARGE HOSE ASSEMBLY (21N X 10 ET) REPAIR.
Refer to para 4-12 for repair of the 2in x 10 ft discharge hose assembly.
4-15. SUCTION HOSE ASSEMBLY (21N X 10 FT) REPAIR.
Refer to para 4-12 for repair of the 21n. x 10 ft. suction hose assembly.
4-16. PRESSURE REDUCING ASSEMBLY REPAIR.
Refer to the following paragraphs to repair components of the pressure reducing skid assembly.
Procedure
Para.
Cover Assembly Repair..............................................................................................................
4-17
Pressure Reducing Assembly Repair..........................................................................................
4-18
Pressure Regulating Valve Assembly Repair..............................................................................
4-19
Skid Assembly Repair ................................................................................................................
4-20
4-15
|
