|
| |
TM 10-4930-240-13
4-6. CHECKING UNPACKED EQUIPMENT-cont
b. Processing Unpacked Equipment.
(1) Remove all tape, paper wrapping, plastic sheeting and packing materials from the AFARE-
components
(2) Inspect stencils, markings and information plates. All items should be clear and readable.
(3) Inspect all components to make sure they are in serviceable condition
(4) Inspect the equipment for any damage incurred during shipment If the equipment has been
damaged,
report the damage on SF 364, Report of Discrepancy.
(5) Check equipment against the packing slip to see if the shipment is complete. Report all
discrepancies in accordance with the instructions of DA Pam 738-750.
(6) Check to see if the equipment has been modified.
SECTION III. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
4-7. GENERAL.
To ensure that the AFARE is ready for use at all times, it must be inspected systematically so that defects may
be discovered and corrected before they result in serious damage or equipment failure.
4-8. PMCS PROCEDURES.
a. Your Preventive Maintenance Checks and Services, Table 4-1, lists inspections and care required to
keep your equipment in good operating condition.
b. The "INTERVAL" column of Table 4-1 tells you when to do a certain check or service.
c. The "LOCATION, ITEM TO CHECK/SERVICE" column of Table 4-1 tells you the name of the item to
be checked or serviced and where the item is located.
d. The "PROCEDURE" column of Table 4-1 tells you how perform the required checks and services.
Follow these instructions carefully
4-4
|
