|
| |
TM10-4930-239- 12&P
4-20. MANIFOLD ASSEMBLY, TYPE 1.
This Task Covers:
Repair
Initial Setup:
TooIs Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Material's Required
Brush, Medium Bristle (Appendix E, Item 2)
Solvent, Dry Cleaning (Appendix E, Item 3)
Cloth, Lint-Free (Appendix E, Item 1)
Gasket, Cork (Appendix E, Item 5)
Washer, Lock, Split (Appendix E, Item 4)
Equipment Condition
Assembly removed from FSSP installation.
Repair. (Refer to Figure 4-11.)
NOTE
Repair is limited to replacement of parts found defective during inspection.
a. Disassembly.
(1) Remove quick disconnect plug (1) and gasket (2) from coupling half (3 ).
(2) Remove quick disconnect plug (4) and gasket (5) from coupling half (6).
(3) Remove quick disconnect cap (7) and gasket (8) from coupling half (9).
(4) Remove quick disconnect cap (10) and gasket (11) from coupling half (12).
(5) Remove eight screws (13), eight flat washers (14), eight lock washers (15), eight nuts (16), gasket (17), and
coupling half (3) from tee (18). Discard gasket (17) and lock washers (15).
(6) Remove eight screws (19), eight flat washers (20), eight lock washers (21), eight nuts (22), gasket (23), and
coupling half (9) from tee (18). Discard gaskets (23) and lock washers (21).
(7) Remove eight screws (24), eight flat washers (25), eight lock washers (26), eight nuts (27), gasket (28), and
coupling half (6) from tee (29). Discard gaskets (28) and lock washers (26).
(8) Remove eight screws (30), eight flat washers (31), eight lock washers (32), eight nuts (33), gasket (34), and
coupling half (12) from tee (29). Discard gaskets (34) and lock washers (32).
4-40
|
