|
| |
TM10-4930-239-12&P
4-31. NOZZLE ASSEMBLY, 1.00 IN.
This Task Covers:
Repair
Initial Setup:
Tools Required
Tool Kit, General Mechanic's (Appendix B, Item 1)
Wrench, Chain (2 Each) (Appendix C, Item 40)
Material's Required
Brush, Medium Bristle (Appendix E, Item 2)
Solvent, Dry Cleaning (Appendix E, Item 3)
Cloth, Lint-Free (Appendix E, Item 1)
Sealing Compound (Appendix C, Item 44)
Equipment Condition
Assembly removed from FSSP installation.
Repair. (Refer to Figure 4-22.)
NOTE
Repair is limited to replacement of parts found defective during inspection.
a. Disassembly.
(1) Remove quick disconnect plug (1) an d gasket (2) from coupling half (3).
(2) Remove coupling half (3) from nozzle (4).
(3) Remove ground wire assembly (5) from nozzle (4).
b. Clean.
(1) Remove all build up of dirt, oil, and debris from all mating surfaces and clamping areas.
WARNING
DO NOT breath dry cleaning solvent vapors for long periods of time or allow
solvent to come into contact with skin for an extended time. DO NOT use solvent
near open flames or excessive heat.
(2) Clean all metallic parts with a clean soft cloth (Appendix E, Item 1) or a medium bristle brush (Appendix E, Item
2), and cleaning solvent (Appendix E, Item 3).
(3) Allow parts to dry.
4-82
|
