|
| |
TM 10-4930-238-12&P
4-13. HOSE ASSEMBLY, DISCHARGE - Continued.
b. R e p a ir - Co ntinued.
c.
4–14
(9) When strapping material stops moving through seal as you turn handle, stop turning. Maximum
tension is being exerted by strapping material around hose.
Failure to back off with tension handle throughout entire course of roll may re-
sult in breaking of strapping and injury to personnel.
(10) Roll tool over seal, backing off with tension handle throughout entire rolling operation.
(11) Pull cutting handle to cut strapping.
(12) Remove tool, holding stub of strapping down with thumb. Clinch stubby hammering down seal
ears.
Installation.
(1)
Refer to Figure 4–6 and connect discharge hoses (1) to wye fitting (2) and closed circuit nozzles
(3).
(2) Push down on camlock levers and secure discharge hoses.
|
