|
| |
TM 10-4930-238-12&P
Table 2-3. Operator’s Filter Separator Controls and lndicators
KEY
CONTROL OR INDICATOR
1
DIFFERENTIAL PRESSURE
INDICATOR
2
SIGHT GAGE
FUNCTION
Indicates differential pressure when filter separator
is on full operating pressure.
Indicates amount of water in filter separator.
Drain water daily or when ball reaches the mark on
body of sight gage.
Section II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
Para.
Para.
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2–5
Operator Preventive Maintenance
Checks and Services . . . . . . . . . . . . . . . . . . . . . . . . . . 2–6
2–5.
INTRODUCTION.
a. General.
(1) Before You Operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your Be-
fore PMCS.
(2) While You Ope rate. Always keep in mind the CAUTIONS and WARNINGS. Perform your During
PMCS.
(3)
After You Operate. Be sure to perform your After PMCS.
(4)
If Your Equipment Fails to Operate. Troubleshoot with proper equipment. Report any deficien-
cies using the proper forms. See DA PAM 738-750.
b. PMCS Procedures.
(1) Purpose of PMCS. Your Preventive Maintenance Checks and Services list the inspections and
care of your equipment required to keep it in good operating condition.
(2) Item Number Column. Checks and services are numbered in chronological order of intervals.
This column is used as a source of item numbers for the “Item Number’’ column on DA Form 2404,
Equipment Inspection and Maintenance Worksheet, in recording results of PMCS.
2–5
|
