|
| |
TM 10-4930-238-12&P
Recoverability
Codes
Application/Explanation
L— Reparable item. Condemnation and disposal not authorized below specialized repair
activity (SRA).
A — Item requires special handling or condemnation procedures because of specific rea-
sons (e.g., precious metal content, high dollar value, critical material, or hazardous
material). Refer to appropriate manuals/directives for specific instructions.
c. CAGE (Column (3)). The Commercial and Government Entitiy Code is a 5-digit numeric code which is
used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
d. PART NUMBER (Column (4)). Indicates the primary number used by the manufacturer, (individual, com-
pany, firm, corporation, or Government activity), which controls the design and characteristics of the item
by means of its engineering drawings, specifications standards, and inspection requirements to identify
an item or range of items.
NOTE
When you use an NSN to requisition an item, the item you receive may have a
different part number from the part ordered.
e. DESCRIPTION AND USABLE ON CODE (UOC) (Column (5)). This column includes the following
information:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
The Federal item name and, when required, a minimum description to identify the item.
The physical security classification of the item is indicated by the parenthetical entry, e.g., Phy Sec
Cl - Confidential, Phy Sec Cl (S) - Secret, Phy Sec Cl (T) - Top Secret.
Items that are included in kits and sets are listed below the name of the kit or set.
Spare/repair parts that makeup an assembled item are listed immediately following the assembled
item line entry.
Part numbers for bulk materials are referenced in this column in the line item entry for the item to be
manufactured/fabricated.
When the item is not used with all serial numbers of the same model, the effective serial numbers are
shown on the last line(s) of the description (before UOC).
The usable on code, when applicable (see paragraph F–5, Special Information).
In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for
each special tool, special TMDE, and other special support equipment. When density of equipments
supported exceeds density spread indicated in the basis of issue, the total authorization is increased
proportionately.
The statement “END OF FIGURE” appears just below the last item description in Column (5) for a giv-
en figure in both Section II and Section Ill.
The indenture, shown as dots appearing before the repair part, indicates that the item is a repair part
of the next higher assembly.
F–5
|
