|
| |
TM 10-4930-229-12&P
Table 2-1. Operator/Crew Preventive Maintenance Checks and Services (PMCS) (cent).
B – Before
D – During
A - After
Interval
Item
Item to be
Equipment is Not
No.
B
D
A
Inspected
Procedures
Ready/Available if:
1
l
b. Check that dust caps and plugs are
Caps or plugs are missing.
(cont)
installed after operation on any
component where caps have been
removed or where disassembly is
required.
2
l
Pump
a. Check air cleaner restriction
Red band is visible on
Assembly
indicator on engine.
indicator.
b. During starting and operation ,
Noise, rough operation, low
check for unusual noise, rough
power, excessive smoke or
operation, lack of power, exces-
indication of defective
sive smoke, or any indication
component.
of defective component.
3
l
Filter-
Check sight gage for evidence of
Water level is high or ball
Separator
water. Ensure ball floats freely. Drain
does not float.
as required.
4
l
Differential
Check that pressure indication is
Pressure indication is in
Pressure
below red band. If yellow, change
red band.
Gage
elements after operation.
Section III. OPERATION UNDER USUAL CONDITIONS
Paragraph
Page
2-11
Assembly and Preparation for Use.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-9
2-12
Operating Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..2-11
2-13
Preparation for Movement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...2-14
2-11. Assembly and Preparation for Use.
a. Set up the equipment as shown in figure 2-4, and install as follows:
WARNING
Weight of hose and component kits and pump assembly exceed limit for one-man lift.
Maximum height for two-man lift is 2.8 feet (84.0 cm).
2-9
|
