|
| |
TM 10-4320-351-14
(5)
Install intake air heaters (6) on intake manifold (7).
(6)
Install power lead (4) and connecting wire (5) on intake air heaters (6). Install boots (3) over terminals.
(7)
If previously removed, attach air filter to air intake adapter (10) with clamp (1).
4.14.7 Replace Decompression Arm O-Rinn. (Refer to figure 4-23.)
This task consists of:
a.
Removal
b.
Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanics
Petrolatum (Appendix F, Section II, Item 10)
(Appendix B, Section III, Item 1)
O-Ring (Appendix I, Item 75)
Equipment Condition:
Pumping assembly shut down. (para. 2.6.)
a.
Removal.
(1)
Remove screws (1) and nuts (2) from decompression lever (3). Remove decompression lever (3).
(2)
Remove screw (4). Remove decompression arm (5).
(2)
Remove O-ring (6) from decompression arm (5). Discard O-ring (6).
b.
Installation.
(1)
Position spacer (7) flush on decompression arm (5) shaft.
(2)
Lightly lubricate with petrolatum and install O-ring (6) on decompression arm (5).
Figure 4-23. Decompression Arm O-Ring Replacement
4-44
|
