|
| |
TM 10-4320-351-14
NOTE
Valve cover with oil fill cap is positioned toward the PTO end of the engine.
(6)
Position valve cover (11) on gasket (12) and cylinder head (9).
(7)
Install and alternately tighten the socket head screws (10) attaching valve covers (11) to cylinder head (9).
(8)
Thread fuel solenoid wire cable through the black start control knob (5), position cylinder casing (8) on engine,
and install and tighten the two socket head cap screws (6) and washers (7) that secure the casing to the cylinder
heads (9).
(9)
Install cable clamp (4) on fuel solenoid cable.
(10)
Position decompression lever (3) and install screws (1) and secure nuts (2).
(11)
Cycle the decompression lever to ensure freedom of movement.
a.
Retaining Nut
d.
Rod
b.
Nozzle
e.
Spring
c.
Distance Ring with
f.
Adjusting Shim
Locating Pin
g.
Injector Casing
Figure 4-20. Fuel Injector Nozzle Cleaning
4-40
|
