|
| |
TM 10-4320-351-14
b.
Installation.
(1)
Position the starter (5) on the engine (6) and loosely install the upper mounting cap screw (3) and washer
(9).
(2)
Install washer (7) and ground leads (8) on cap screw (4), and install in lower mounting hole. Remove tags.
(3)
Tighten both mounting cap screws.
(4)
Install electrical leads (1) to solenoid as tagged. Remove tags.
4.14.2 Replace Fuel Pump. (Refer to figure 4-17.)
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanics
Washer (Appendix I, Item 32)
(Appendix B, Section III, Item 1)
Nut, Self-Locking (Appendix I, Item 1)
General Safety Requirements:
Equipment Condition:
Pumping assembly shut down. (para 2.6)
WARNING
·
Fuels are toxic and flammable. Do not get on person
or clothing. Work in well ventilated area. Do not
smoke. Ensure equipment is well grounded.
a.
Removal.
(1)
Disconnect fuel feed line (1) from fuel pump (2). Remove union bolt (3), union (4) and two copper washers
(5 and 6). Discard copper washers (5 and 6).
(2)
Disconnect fuel supply line (7) from fuel pump (2). Remove union bolt (8), union (9) and two copper
washers (10 and 11). Discard copper washers (10 and 11).
(3)
Remove the two self-locking nuts (12) that attach the fuel pump to the block (13). Discard the self-locking
nuts (12).
(4)
Remove the fuel pump (2), drive rod (14) and gasket (15).
b.
Installation.
(1)
Clean gasket surface on block (13).
(2)
Install gasket (15) over mounting studs (16).
4-34
|
