|
| |
TM 10-4320-351-14
(2)
From rear of electrical connection panel, insert control cable connector 1A1J2 (8) through center hole in
panel, position and hold the mounting flange on rear of connector, and install and tighten the four cross tip
screws and flat washers that secure connector 1A1J2 to the module frame.
(3)
From rear of electrical connection panel, insert pumpage overtemperature connector 1A1J3 (7) through
right-hand hole in panel, position and hold the mounting flange on rear of connector, and install and tighten
the four cross tip screws and flat washers that secure connector 1A1J3 to the module frame.
(4)
Connect alternator wires (6) at in-line connectors as tagged.
(5)
Connect small electrical wire (5) to starter solenoid as tagged.
(6)
Connect electrical wire to oil pressure switch (4) as tagged.
(7)
At intake manifold, connect electrical wires to air intake heaters (3) as tagged. Install boots over
connectors.
(8)
Install electrical wire to engine temperature sensor (2) as tagged.
(9)
Connect fuel shutoff solenoid electrical wires (1) at in-line connectors as tagged.
(10)
Group and route wires of cable assembly W101 in general layout observed at removal, and install tiedown
straps as necessary to secure wiring harness.
4.14 ENGINE ASSEMBLY MAINTENANCE.
4.14.1 Replace Starter. (Refer to figure 4-16.)
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanics
Tags, Electrical (Appendix F, Section II, Item 16)
(Appendix B, Section III, Item 1)
Equipment Condition:
Pumping assembly shut down. (para. 2.6)
a.
Removal.
(1)
Tag and remove electrical leads (1) from solenoid (2).
(2)
Loosen the two cap screws (3 and 4) that secure the starter (5) to the engine block (6).
(3)
Tag leads, and remove the lower cap screw (4), washer (7) and ground leads (8).
(4)
Support the starter and remove the upper cap screw (3) and washer (9). Remove the starter.
4-32
|
