|
| |
TM 10-4320-351-14
4.13.4 Replace Cable Assembly W101. (Refer to figure 4-15.)
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanics
Tags, Electrical (Appendix F, Section II, Item 16)
(Appendix B, Section III, Item 1)
Strap, Tiedown (Appendix F, Section II, Item 8)
Equipment Condition:
Engine module removed from pump-engine
module. (para. 2.4.b)
a.
Removal.
NOTE
Before beginning removal of cable harness W101, observe general layout of cable
harness as guide to installation.
(1)
Cut and remove tiedown straps from electrical wiring harness.
(2)
Tag and disconnect fuel shutoff solenoid electrical wires (1) at in-line connectors in wiring harness.
(3)
Tag and disconnect electrical wire from engine temperature sensor (2).
(4)
At intake manifold, lift boots from air intake heaters (3). Tag and remove electrical wires from air intake
heaters.
(5)
Tag and remove electrical wire from oil pressure switch (4).
(6)
Tag and remove small electrical wire (5) from starter solenoid.
(7)
Tag and disconnect alternator wires (6) at in-line connectors.
(8)
At pumpage overtemperature connector 1A1J3 (7), remove the four cross tip screws and flat washers that
secure connector 1A1J3 to module frame. Remove connector; retain mounting flange from rear of
connector.
(9)
At control cable connector 1A1J2 (8), remove the four cross tip screws and flat washers that secure
connector 1A1J2 to the module frame. Remove the connector; retain the mounting flange from rear of
connector.
(10)
At rear of NATO connector 1A1J1 (9), tag and remove the small electrical wires (3 terminal lugs) from the
negative terminal of connector 1A1J1.
b.
Installation.
(1)
At rear of NATO connector 1A1J1 (9), install the small electrical wires (3 terminal lugs) to the negative
terminal of connector 1A1J1 as tagged.
4-30
|
