|
| |
TM 10-4320-351-14
j. Close and latch control box cover.
NOTE
Control cable W201 is separated into two legs. The shorter leg connects to the
pumpengine module. The longer leg is used to supply power to the auxiliary pump
module and should not be removed from storage cabinet until required for use.
k. Remove control cable W201, short leg, from the storage cabinet in the accessory module, route through cut
out on upper lip of cabinet and connect to connector 1A1J2 on the engine module. Connect adjacent dust
caps together.
l. Remove battery power cable from storage cabinet in the accessory module, route through cut out on upper lip
of cabinet and connect to NATO connector 1A1J1 on engine module. Connect adjacent dust caps together.
m. Verify that both cables are in storage cabinet cut out, then close and latch storage cabinet cover.
n. Position ENGINE switch to RUN and observe the malfunction indicators. Failure to achieve the following
indicates a system fault. Determine cause before attempting to operate the pumping system.
(1) PUMPAGE HOT indicator flashes once.
(2) ALTNTR indicator illuminates.
(3) LOW OIL PRESSURE indicator illuminates.
(4) ENGINE HOT indicator does not illuminate.
o. Place FAULT LIGHTS switch in BLACKOUT position.
p. Restore ENGINE switch to STOP position.
q. Position a fire extinguisher adjacent to pump-engine module.
r. Fill engine fuel tank or connect external fuel source.
s. If provided, install acoustic cover.
2-15
|
