|
| |
TM 10-4320-351-14
6.4.29 INSTALL ENGINE IN ENGINE MODULE. (Refer to figure 6-52.)
a.
Attach hoist to engine lifting eye, raise engine and position above engine module with engine pulley aligned with
pulley guard (1) on module.
b.
Lower pulley guard (1) and carefully lower replacement engine into module frame, aligning mounting holes in
frame and engine.
c.
Install and alternately tighten the ten bolts (2), lock washers and flat washers that secure the engine to the frame.
Remove hoist (or blocks) and check that mounting bolts are securely tightened.
d.
Locate alternator wires (3) in wiring harness and connect at in-line connectors as tagged. Remove tags.
e.
At lower starter mounting bolt (4), connect starter ground cable and other ground wires as tagged. Remove tags.
f.
At starter solenoid, install the cables (5) and other wires as tagged to the solenoid studs. Remove tags.
g.
At the oil pressure switch (6), connect the switch wire as tagged. Remove tag.
h.
At intake manifold, connect the electrical wires (7) to the air intake heaters as tagged. Remove tags. Place boots
(8) over connector.
i.
Connect the engine temperature sensor wire (9) at in-line connector in wiring harness as tagged. Remove tag.
j.
Locate the fuel shutoff solenoid wires (10) and connect to the wiring harness as tagged. Remove tags.
k.
Group and route wires of cable in general layout observed at removal, and install wire ties as necessary to secure
wiring harness.
l.
Install fuel return line at fuel fitting (11) on #2 fuel injection pump.
m.
Install fuel supply line (12) on fuel pump (13).
n.
Install carrying handles. Refer to paragraph 4.13.1.
o.
Raise and latch pulley guard.
p.
Install engine module in pump-engine module. Refer to paragraph 2.4.d.
6-83
|
