|
| |
TM 10-4320-351-14
6.4.25 Install Oil Pan and Oil Filter. (Refer to figure 6-49.)
This task consists of:
a. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
7/8 in combination wrench
Gasket, Pan (Appendix I, Item 21)
(Appendix B, Section III, Item 3)
6 mm socket
(Appendix B, Section III, Item 3)
3/8 in. drive ratchet wrench
(Appendix B, Section III, Item 3)
10 mm socket
(Appendix B, Section III, Item 3)
6 mm socket head wrench
(Appendix B, Section III, Item 3)
Equipment Condition:
Oil pan removed (para. 6.3.1)
a.
Install cap screw (1), washer (2) and net (3).
b.
Position pan gasket (4) on oil pan (5).
c.
Insert and tighten in an alternating pattern the fifteen socket head cap screws (6) and washers (7) attaching oil
pan (5) to the crankcase (8).
d.
Install oil drain plug (9) and washer (10).
e.
Install oil temperature sensor (11). Torque to 22.11-29.48 ft. lbs. (30-40 Nm).
f.
Install dipstick (12).
g.
Loosely install oil filter (13). (Oil filter (13) must be removed later for fuel injector timing.)
6-77
|
