|
| |
TM 10-4320-351-14
6.4.24 Install Fuel Flow Solenoid. (Refer to figure 6-48.)
This task consists of:
a. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Socket, Socket Wrench, 5 mm
O-Ring (Appendix I, Item 29)
(Appendix B, Section III, Item 3)
Gasket (Appendix I, Item 19)
Ratchet Wrench, 3/8 in. Drive
(Appendix B, Section III, Item 3)
Extension, 6 in., 3/8 in. Drive
(Appendix B, Section III, Item 3)
Equipment Condition:
Fuel injectors installed (para. 6.4.20)
a.
Insert O-ring (1) in crankcase.
NOTE
When the solenoid is installed in the crankcase, ensure solenoid arm is positioned
to the right of the control rod center lever arm.
b.
Hold control rod (2) center lever arm (3) fully to the left, position solenoid (4) on crankcase and install two socket
head screws (5) to attach solenoid to crankcase. Release control rod (2) and verify that solenoid arm (6) is to the
right of the control rod center lever arm (3).
c.
Loosely install the five socket head screws (7) and flat washers (8) to attach the fuel control cover (9) and gasket
(10) to the crankcase. (Fuel control cover (9) must be removed later for injector timing.)
6-75
|
