|
| |
TM 10-4320-351-14
6.4.15 Install Intake Manifold.
Refer to paragraph 4.14.6.
6.4.16 Install Exhaust Manifold.
Refer to paragraph 4.14.5.
6.4.17 Adjust Valves.
Refer to paragraph 4.14.3.
6.4.18 Install Injection Pump. (Refer to figure 6-42.)
This task applies to either injection pump.
This task consists of:
a. Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Combination Wrench, 13 mm
Safety wire, 0.032
(Appendix B, Section III, Item 3)
(Appendix F, Section II, Item 22)
Combination Wrench, 17 mm
Gasket (Appendix I, Item 16)
(Appendix B, Section III, Item 3)
Pliers, Needle Nose
(Appendix B, Section III, Item 3)
Equipment Condition:
Injection pump installed (para. 6.4.18)
a.
Install tappet (1) in crankcase (2). If reinstalling previously used tappet, ensure tappet is reinstalled in same hole.
NOTE
Injection pumps are supplied by two different manufacturers: Ruggerini and
Bosch. Ruggerini injection pumps do not have expansion plugs (3).
b.
Install expansion plug (3) in crankcase (2).
c.
Install gaskets (4) in crankcase (2).
d.
Rotate flywheel counterclockwise until tappet (1) is resting in down position.
NOTE
When installing spring clips (5), run a length of safety wire through the eye of the
clip to prevent the clip from falling into the crankcase (2).
e.
Attach control rod (6) to governor joint (7) and secure with spring clip (5).
f.
Position injection pump (8) in crankcase (2). Ensure injection pump (8) is in same position as it was removed
from. Ensure same number of gaskets (4) that were removed are placed between fuel injection pump (8) and
crankcase (2).
6-67
|
