|
| |
TM 10-4320-351-14
6.3 ENGINE DISASSEMBLY.
6.3.1 Remove and Clean Oil Pan. (Refer to figure 6-2.)
This task consists of:
a. Removal
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Key, Socket Head Screw, 6 mm
None
(Appendix B, Section III, Item 3)
Key, Socket Head Screw, 5 mm
(Appendix B, Section III, Item 3)
Socket, 10 mm
Equipment Condition:
(Appendix B, Section III, Item 3)
Engine removed from engine module
Socket, 13 mm, deep well
(para. 6.2)
(Appendix B, Section III, Item 3)
Engine oil drained
Ratchet wrench, 3/8" drive
(Table 4-1)
(Appendix B, Section III, Item 3)
a
Remove dipstick (1).
b.
Place engine on pulley end.
c.
Rotate engine to a position to allow for oil pan removal.
d.
Remove the fifteen cap screws (2) and flat washers (3) attaching oil pan (4) to crankcase (5). Remove oil pan.
e.
Remove gasket (6) and clean gasket residue from crankcase and oil pan.
f.
Remove cap screw (7), washer (8) and net (9). Inspect and clean net and oil pan. Reinstall net.
6-5
|
