|
| |
TM 10-4320-351-14
Figure 5-12. Emergency Stop Switch Replacement
c.
Installation.
(1)
Insert operator (red button) (10) through control panel (3), slip mounting base (9) over operator (red button)
(10) and hold in place while tightening the two compression screws (8). Test operation for assurance of
proper mounting and mechanical action.
NOTE
Contact blocks are keyed so they will only fit one way.
(2)
Install contact blocks (4) on mounting base (9).
(3)
Remove terminals (6) from contact block (4). Solder wires as tagged to terminals (6).
(4)
Install terminals (6) onto contact block with wire terminal retaining screws (5). Remove tags.
(5)
Install two contact blocks (4) with two contact block retaining screws (7) onto mounting base (9).
(6)
Install control panel (3) in control box with twenty-four screws (1) and flat washers (2).
5-32
|
