|
| |
TM 10-4320-351-14
l.
Add one pint MIL-L-644B preservative oil to fuel tank; fill tank with fuel.
m.
Start and run engine for approximately ten minutes at half speed to fill engine fuel system components with
preservative oil.
n.
Stop engine.
o.
Remove all fuel and electrical lines from engine module, and remove engine module from pump-engine
module.
p.
Drain oil from engine crankcase and dispose of in accordance with SOP.
q.
Spray light oil in the intake and exhaust manifolds.
r.
Thoroughly clean all external engine surfaces.
s.
Apply MIL-C-16173 corrosion prevention compound to all unpainted external engine surfaces.
t.
Tape over all engine openings.
u.
Wrap the module in plastic sheeting and store in a dry place.
4.16.1.2 Preparation for Long Term Storage (More Than Six Months).
a.
Prepare for short term storage. Refer to paragraph 4.16.1.1
b.
Inspect every six months for rust or corrosion. Clean as required and apply MIL-C-16173 corrosion
prevention compound to cleaned surfaces.
4.17
PREPARATION FOR SHIPMENT.
The pump-engine module and accessory module are shipped and stored as part of the Advanced Aviation Forward Area
Refueling System (AAFARS). To prepare the pump-engine and accessory modules for shipment, perform the following
steps:
a.
Pump-engine module:
(1)
If necessary, remove the air filter (para. 4.9.3) and store it in the accessory module.
(2)
Drain the crankcase (table 4-1).
(3)
Drain the fuel tank into an approved container using a short length of hose and the fuel drain valve on
the bottom of the fuel tank.
(4)
Replace the fuel filter (para. 4.9.1).
(5)
Defuel the fuel transfer pump (para. 4.12.1).
b.
Accessory module:
(1)
Disconnect battery power cable at battery (para. 2.5).
(2)
Ensure all covers are latched.
4-56
|
