|
| |
TM 10-4320-351-14
4.15.5 Repair Battery Holddown. (Refer to figure 4-28.)
NOTE
This procedure applies to either battery holddown.
This task consists of:
a.
Disassembly
b.
Assembly
INITIAL SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanics
Nut, Self-Locking (Appendix I, Item 66)
(Appendix B, Section III, Item 1)
Washer, Lock (Appendix I, Item 62)
Washer, Lock (Appendix I, Item 64)
General Safety Requirements:
Equipment Condition:
Accessory module removed from system
(para. 2.6)
Battery removed from accessory module
(para. 4.15.1)
a.
Disassembly.
(1)
At accessory module, unlatch and raise battery compartment cover (1).
(2)
At holddown eyebolt (2), remove wingnut (3), two flat washers (4), lock washer (5) and self-locking nut (6).
Discard lock washer (5) and self-locking nut (6).
(3)
At bottom of eyebolt (2), remove shoulder bolt (7), flat washer (8), lock washer (9) and hex nut (10).
Discard lock washer (9). Remove eyebolt from battery compartment.
b.
Assembly.
(1)
Insert eyebolt (2) through bottom of battery compartment, align eye with mounting hole in frame, and install
shoulder bolt (7), flat washer (8), lock washer (9) and hex nut (10).
(2)
At upper end of holddown eyebolt (2), install self-locking nut (6), two flat washers (4), lock washer (5) and
wingnut (3).
(3)
Adjust wingnut for snug fit of holddown assembly under battery ear.
4-52
|
