|
| |
TM 10-4320-351-14
CAUTION
Make sure each cable is connected to the same polarity terminal in each connector
("+" to "+ " and "-" to "-"). Equipment damage may result from improper
connections.
(3)
At the NATO connector (3), slide the jam nuts (7), bushings (10) and packings (11) onto the cables and
insert the cables into the connector (3).
(4)
Install the two bolts (8) and lock washers (9) to secure cables to connector (3) and tighten jam nuts (7).
Observe proper polarity. Ensure cable connected to "-" terminal of battery connector is connected to "-"
terminal of NATO connector.
(5)
Install the six cross tip screws (4) and washers (5) that secure the cover (6) to the connector. Ensure the
cover lanyard is secured to one of the screws.
(6)
Install tiedown straps as required. Thread tiedown straps through slots in cable tags and attach to cable,
one near each end and one near the middle.
d.
Installation.
(1)
At the accessory module, push battery connector through lower cut out in cable storage compartment (2)
and install connector on battery. Coil remainder of cable in cable storage compartment (2).
(2)
Close and latch the center cover (1) and cable storage compartment cover (2).
4.15.4 Replace Control Cable (W201). (Refer to figure 4-27.)
This task consists of:
a.
Removal
b.
Installation
INITIAL SET-UP:
Tools:
Materials/Parts Required:
No tools required
None
General Safety Requirements:
Equipment Condition:
None
Accessory module removed from system.
(para. 2.9)
a.
Removal.
(1)
At the accessory module, open the center cover (1) and cable storage compartment cover (2).
(2)
Disconnect control cable W201 (3) from control box.
(3)
Install dust caps on control cable (3) and control box connector.
(4)
Push control cable through upper cut out (4) into cable storage compartment and remove from accessory
module.
4-50
|
