|
| |
TM 10-4320-348-14
(5)
Install valve springs (6).
NOTE
Rocker arm with flat head is for the exhaust valve only.
(Refer to Figure 6-1)
(6)
Place new cylinder head gasket (10) and push rod O-ring (9) onto cylinder block.
(7)
Install cylinder head (8) onto four studs protruding from cylinder block.
(8)
Position push rods (11) into cylinder block in the cam followers.
(9)
Secure cylinder head (8) to cylinder block using two cap nuts (3) and washers (2).
(10)
Tighten nuts using torque wrench to 20-23 ft-lb (280-320 kg-cm).
(Refer to Figure 6-2)
(11)
Install valve stem caps (5).
(12)
Install rocker arm support (2) with intake and exhaust valve rocker arms attached.
(13)
Tighten rocker arm support bolt (1) with torque wrench to 14-16 ft-lb (200-220 kg-cm).
e.
Adjustment.
Adjust valve clearance per ADJUSTMENT procedure in paragraph 4.32.
6-7/(6-8 Blank)
|
