| |
TM 10-4320-348-14
5.7 DIESEL ENGINE REPLACEMENT.
This task covers:
a) Removal
b) Inspection
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, General Mechanics
4.10 Engine oil drained.
(Appendix B, Section III, Item 1)
4.20 Sound enclosure rear panel assembly removed.
4.22 Three-way valve and hoses removed.
Materials/Parts
4.22 Mechanical controls and indicators and front panel
Gasket (Appendix I, Section II, Item 24)
removed.
4.24 Crankcase oil immersion heater removed.
4.26 Fuel tank removed.
4.28 Air intake baffle and cooling case cover removed.
4.29 Air filter removed.
5.6 Pump casing removed.
a. Removal. (Refer to Figure 5-5)
(1)Remove clamp (1), oil drain hose (2), fitting (3), and gasket (4) from engine (5). Discard gasket (4).
(2)Remove four self-locking nuts (6) and four washers (7) attaching engine (5) to engine base plate (8). Push aside
ground wire (9).
(3)Remove engine (5) and four washers (10) from engine base plate (8).
b. Installation.
(1)Place four washers (10) and engine (5) on engine screws (11).
(2)Place ground wire (9) on one of the screws (11) and then install four washers (7) and four self-locking nuts (6).
(3)Install gasket (4), fitting (3), oil drain hose (2), and clamp (1) onto engine (5).
5-11
|