|
| |
TM 10-4320-348-14
(8)Install spring (14) and spring seat (15) onto shaft adapter (7).
(9)Screw impeller (4) onto shaft adapter (7) until tightened.
(10)Install flat washer (3), teflon washer (2) onto locking bolt (1).
(11)Install locking bolt (1) into shaft adapter (7) and tighten.
(Refer to Figure 5-2)
(12)Install new o-ring (7) into volute cover (2).
(13)Attach volute cover (2) onto pump casing (3) with two washers (5) and two hexnuts (4). Ensure that large
opening on volute cover (2) is lined up with priming port.
5-8
|
