|
| |
TM 10-4320-348-14
(g)
Tie a knot in the rope (2) and feed through plastic reel (6).
(h)
Pull enough rope (2) through T-handle (1) to make a knot.
(i)
Remove bracing screwdriver and let reel rewind rope (2) slowly.
(j)
Check the recoil starter assembly (4) for proper operation before installing the recoil starter assembly (4) on
the engine.
d.
Installation.
(1)
Check recoil starter assembly (4) for operation before installing it on the engine.
(2)
Position recoil starter assembly (4) on the cooling case cover as noted at removal. Push the cam back into
the assembly if it is extended.
(3)
Install four bolts (5).
(4)
Untie the temporary knot in the rope (2) and feed the rope (2) through sound enclosure front panel grommet
(3).
(5)
Install T-handle (1) on rope (2). Thread enough rope (2) through the T-handle (1) to make a knot.
(6)
Tie a knot in the rope (2) and pull it against the hole in the T-handle (1). Stuff excess rope into the T-handle
slot.
(7)
Check recoil starter assembly (4) for operation on the engine.
4-49
|
