|
| |
TM 10-4320-347-13&P
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
SECTION I. DIRECT SUPPORT REPAIR PARTS, SPECIAL TOOLS, TEST
MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE),
AND SUPPORT EQUIPMENT
5.1. COMMON TOOLS AND EQUIPMENT . For authorized common tools and equipment, refer to the
Modified Table of Organization and Equipment (MTOE) applicable to your unit.
5.2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT . No special tools are required to service
the pumping assembly. The standard tools in the general mechanic's tool kit listed in the Maintenance
Allocation Chart (MAC) located in Appendix B of this manual are the only tools required for maintenance
of the pumping assembly.
5.3. REPAIR PARTS. Repair parts are listed in the Repair Parts and Special Tools List in Appendix C
of this technical manual.
SECTION II. DIRECT SUPPORT TROUBLESHOOTING
5.4. GENERAL. No direct support troubleshooting procedures are applicable to the pumping assembly.
SECTION III. DIRECT SUPPORT MAINTENANCE PROCEDURES
5.5. DIRECT SUPPORT MAINTENANCE PROCEDURES . Maintenance procedures at direct support
maintenance level include as necessary: removal, cleaning and inspection, repair or replacement, and
installation.
5-1
|
