|
| |
TM 10-4320-347-13&P
2.11. OPERATING PROCEDURES. - Continued.
Figure 2-4. Priming Pump.
b. Starting and Operating. After insuring that the pump assembly has been properly assembled as indicated
in paragraph 2.9 and that the pump has been initially primed as defined in step a. above, the pump assembly
may be operated by performing the following steps. (Refer to Figure 2-5.)
(1) Perform all "Before" Operator PMCS listed in Table 2-1.
(2) Place the toggle switch (1) on the motor housing in the ON position to turn on the pump
motor.
WARNING
Improper care in handling fuel can cause fire and explosion
which can cause severe injury or death to operating personnel.
To avoid fire or explosion during engine refueling:
DO NOT allow any flame producing material within 50 feet
(15.25 m) of fuel during equipment filling.
DO NOT smoke while transferring fuel.
DO NOT let fuel drip onto any hot surface.
DO NOT overfill any fuel container.
(3) Place the spout of the nozzle assembly (2) into the container which is to be filled with fuel and
depress the handle (3) of the nozzle assembly to dispense fuel.
(4) When fuel transfer is complete, release the handle (3) on the nozzle assembly (2) to stop the
flow of fuel from the nozzle spout.
2-13
|
