| |
TM 10-4320-347-13&P
APPENDIX H
MANDATORY REPLACEMENT PARTS
SECTION I. INTRODUCTION
H.1. SCOPE. This appendix lists mandatory replacement parts you will need to have when performing
maintenance on the Pumping Assembly. Any time a maintenance procedure is performed that requires you to
remove any of the items shown on this list, you are required to replace that item with a new one. You will know
that your procedure requires one of these replacement parts when the statement "(Appendix H, Item X)"
appears in the "Materials Required" area of the Initial Setup portion of the maintenance procedures in Chapter
4.
H.2. EXPLANATION OF COLUMNS . The table shown in Section II identifies the parts which must be replaced
during maintenance of the Pumping Assembly. An explanation of the columns in each in this table is as follows.
a.
Column (1) - Item number . This number is assigned to the entry in this listing and is referenced in the
narrative instructions to identify the material (e.g., "Rivet (Appendix I, Item 1").
b.
Column (2) - CAGEC. The Contractor and Government Entity Code (CAGEC) is a 5-digit numeric
code which is used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
c.
Column (3) - Part Number. Indicates the primary number used by the manufacturer (individual,
company, firm, corporation, or Government activity), which controls the design and characteristics of the item
by means of its engineering drawings, specifications standards, and inspection requirements to identify an item
or range of items.
d.
Column (4) - Nomenclature. This column identifies the common name for the part in accordance with
the name given to the part on the applicable engineering drawing or specification.
H-1
|