|
| |
TM 10-4320-343-14
SECTION II. SERVICE UPON RECEIPT
4.4 SERVICE UPON RECEIPT OF MATERIEL.
4.4.1 Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment.
If the equipment
has been damaged, report the damage on SF 361, Report of Discrepancy.
b.
Check the equipment against the packing slip to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions in
DA Pam 738-750.
c .
Check to see whether the equipment has been modified.
4.4.2 Processing Unpacked Equipment.
Refer to DA Form 2258, Depreservation Guide for Vehicles and Equipment, packed with
the equipment.
The depreservation guide explains what was done to the equipment
prior to packaging.
It also explains what has to be done before placing the
equipment in operation.
Perform all depreservation actions required by the
depreservation guide.
4.5 INSTALLATION INSTRUCTIONS.
4.5.1
t o o l
4.5.2
Tools, Test Equipment, and Materials Required for Installation. A general mechanic's
kit is required for installation of the equipment.
Installation Instructions. Perform the following:
Do not fill battery without rubber gloves and protective
c l o t h i n g.
Electrolyte causes serious burns.
Failure to obey
this warning may result in personal injury or death.
NOTE
The following installation procedure must be made with the assistance of
direct support level maintenance personnel.
If batteries were shipped dry, remove and fill with electrolyte to a
level 3/8 inch (9.5 mm) above cell plates.
Install batteries, attach cables, covers, and hold-down bar (paragraph
4 .
1
2 .
2 .
Move equipment to worksite (paragraph 2.7.2).
Refer to paragraph 2.3 for preparation for use of 350 GPM pumping assembly.
a .
b .
c .
d.
4.6 PUMP ASSEMBLY LUBRICATION.
Refer
to
10-4320-343-12
for
lubrication
instructions.
4-3
|
