|
| |
TM 10-4320-343-14
a.
b .
c .
d .
e .
f .
g .
h.
To prevent rolling or sliding, do not work on equipment that
is not securely stabilized.
Ensure both wheels are secure.
Failure to obey this warning may result in personal injury.
Ensure that fuel tank does not run dry, otherwise fuel filter
and injection lines will require bleeding of air from fuel
system.
Observe strict cleanliness during replenishing of fuel tank.
At low ambient temperatures, use winter grade fuel only.
Observe fuel gauge (figure 3-5, 1) for fuel level.
When below 1/4 tank,
perform remaining steps of this procedure.
Do not fill fuel tank while equipment is operating.
Do not smoke or
use open flames while filling tank.
Avoid inhalation of fumes from
f u e l.
Failure to obey this warning may result in personal injury or
death.
Remove tank filler cap (2) and inspect gasket (3) for damage.
Ensure that vent valve on tank filler cap (2) is open.
Remove filler neck (4) from fuel tank (5) and inspect filler neck.
Clean as
necessary.
Install filler neck (4) into fuel tank (5).
Refill fuel tank (5) until fuel is one inch from top of tank.
I n s t a l l t a n k f i l l e r c a p ( 2 ).
Observe fuel gauge (l).
Fuel gauge should indicate full.
If not, n o t i f y u n i t
maintenance.
3-13/(3-14 blank)
NOTE
|
