| |
TM 10-4320-343-14
b.
Disconnect suction hose (1, figure 2-9) from coupler half (2) and connect quick disconnect plug (3) to coupler half
(2).
c.
Disconnect discharge hose (4) from coupler half (5) and connect quick disconnect cap (6) to coupler half (5).
d.
Remove ground cable and store in tool box (7).
e.
Remove ground rod and store on frame (8).
f.
Remove quick release pins (1 and 2, figure 2-10) from tongue(3) and extend tongue extension to full length.
g.
Insert quick release pins (1 and 2) and secure tongue(3).
h.
Release pintle hook (4) and connect pumping assembly to towing vehicle (5).
i.
Attach and secure 350 GPM Pumping Assembly to towing vehicle (5).
j.
Remove pins (6 and 7) and push upward on trailer support legs (8) until holes align with mounting holes for pins
(6 and 7).
k.
Reinstall pins (6 and 7) to secure trailer support legs (8) and remove chock (9) from wheel (10).
CAUTION
Do not tow 350 GPM Pumping Assembly more that 20 miles per hour (mph).
Failure to obey this caution could result in equipment damage.
n.Tow 350 GPM Pumping Assembly to new location at worksite.
2.7.2 Preparation for Movement to New Worksite. Perform the following to move 350 GPM Pumping Assembly to
another worksite.
a.
If operating, perform shutdown procedures in paragraph 2.5.1.2 for non-regulated models and paragraph 2.5.2.2
for regulated models.
b.
Disconnect suction hose (1, figure 2-9) from coupler half (2) and connect quick disconnect plug (3) to coupler half
(2).
c.
Disconnect discharge hose (4) from coupler half (5) and connect quick disconnect cap (6) to coupler half (5).
d.
Remove ground cable and store in tool box (7).
e.
Remove ground rod and store on frame (8).
f.
Attach lifting equipment to 350 GPM Pumping Assembly and lift: equipment on flatbed trailer.
g.
Secure the 350 CPM Pumping Assembly on trailer or vehicle.
h.
Transport 350 GPM Pumping Assembly to new worksite location.
Change 1 2-31
|