|
| |
TM 10-4320-343-14
NOTES
1.
EACH WIRE SHALL BE MARKED ON BOTH ENDS WITH APPROPRI ATE WIRE NO. AS SHOWN IN
TABULATION BLOCK.
EXAMPLE: TB1 Ö S1-1
PERMANENCY LEGIBILITY AND TYPE OF LETTERING SHALL BE IN ACCORDANCE WITH MIL-STD-130.
2.
WIRING SHALL BE BUNDLED IN ACCORDANCE WITH REQUIREMENT 69 OF MIL-STD-454.
3.
ROUTING CHANGES MAY BE MADE TO FACILITATE INSTALLATION.
4.
INSTALL TERMINALS TO MEET THE PERFORMANCE REQUIREMENTS OF MIL-T-7928.
5.
BUNDLE WIRING WITH TIE WRAPS.
6.
MARK WIRING IN ACCORDANCE WITH MIL-STD-130.
Figure F-3. Control Panel Wiring Harness Assembly (Model 350 PAFN) (Sheet 1 of 2).
F-10 Change 1
|
