|
| |
TM 10-4320-343-14
NOTES
1. EACH WIRE SHALL BE MARKED ON BOTH ENDS WITH APPROPRIATE WIRE NO.AS SHOWN IN TABULATION
BLOCK.
EXAMPLE: TB1 Ö S1-1
PERMANENCY LEGIBILITY AND TYPE OF LETTERING SHALL BE IN ACCORDANCE WITH MIL-STD-130.
2. ROUTING CHANGES MAY BE MADE TO FACILITATE INSTALLATION.
3. WIRING SHALL BE BUNDLED IN ACCORDANCE WITH REQUIREMENT 69 OF MIL-STD-454.
4. INSTALLED TERMINALS, FIND NO. 16-22, SHALL MEET THE PERFORMANCE REQUIREMENTS OF MIL-T-454,
REQUIREMENT 19.
5. BUNDLE CABLE AND TIE WRAP USING STRAP FIND NO. 25 AS REQUIRED.
6. MARK HARNESS IN ACCORDANCE WITH MIL-STD-130.
Figure F-2. Control Panel Wiring Harness Assembly (All Except Model 350 PAFN) (Sheet 1 of 3).
Change 1 F-7
|
