|
| |
TM 10-4320-343-14
6.6.4 Engine Maintenance.
This task covers:
6.6.4.1 Disassembly
6.6.4.3 Assembly
6 .6 . 4 . 2 R e p a i r
INITIAL SETUP
Tools
General Mechanic’s Tool Box (appendix B,
Section III, Item 1)
Inside micrometer (appendix B,
Section III, Item 3)
Micrometer (appendix B, Section III,
Item 3)
Torque wrench, 0 - 150 ft lbs (appendix B,
Section III, Item 3)
Angle of Turn Indicator (appendix B,
Section III, Item 10)
Crankshaft Seal Installer (appendix B,
Section III, Item 13)
Refacing Device (appendix B, Section III,
Item 24)
Bolt Degree Gauge (appendix B,
Section III, Item 23)
Gasket Extractor (appendix B, Section III,
Item 25)
Crankshaft Seal Installer (appendix B,
Section III, Item 26)
Material/Parts
Lockwashers (TM 10-4320-343-24P)
Gaskets (TM 10-4320-343-24P)
Reference
LO 10-4320-343-12
Equipment Conditions
Air cleaner removed, paragraph 4.10.5.
Alternator removed, paragraph 4.10.12.
Starter Assembly removed,
paragraph 4.10.13.
V-belt contact switch removed,
paragraph 4.12.9.
Shutdown solenoid removed,
paragraph 4.10.14.
Fuel lines, hoses and fittings removed,
paragraph 4.13.4.
Crankshaft pulley removed
paragraph 5.5.10.
Injection pump removed,
paragraph 5.5.5.
Cooling fan removed, paragraph 5.7.2.
Engine cowlings removed,
paragraph 5.5.8.
Cylinder head removed, paragraph 6.6.1.
Engine removed paragraph 5.5.1 and
placed on engine stand.
011 drained, LO 10-4320-343-12
General Safety Instructions
Do not use dry cleaning solvent without
proper ventilation and clothing.
Do not work on equipment without
following standard shop safety
precautions.
6.6.4.1 Disassembly.
a .
Remove four bolts (figure 6-7, 1), washers (2), one motor mount (3) and four
washers (4).
6-19
|
