| |
TM 10-4320-343-14
Do not lift heavy assemblies without lifting device.
Failure to obey this
warning may result in personal injury or death.
d.
Place sling of adequate size around centrifugal pump (12) and attach engine
s l i n g.
e .
Place a jackstand under each side of the rear trailer frame for support.
f .
With weight of centrifugal pump (12) on engine sling, slowly and carefully
pull centrifugal pump (12) back until flexible coupling disengages from
connection ring.
g .
Pull centrifugal pump (12) completely clear of engine.
h.
Carefully remove centrifugal pump (12) clear of frame.
i .
Tag and remove any shims.
Retain shims for installation.
5.6.1.2 Installation.
Do not lift heavy assemblies without lifting device.
Failure to obey this
warning may result in personal injury or death.
a.
Place lifting strap of adequate size around centrifugal pump (12) and connect
engine sling.
b.
Raise centrifugal pump (12) and position over frame.
c .
Slowly lower centrifugal pump (12), aligning flexible coupling with connection
ring observed through openings (13) on either side of intermediate bracket.
d.
Push centrifugal pump (12) toward engine and guide flexible coupling until
coupling engages with coupling on engine.
e .
Secure centrifugal pump (12) as follows:
(1) Install shims between pump and frame. Remove tags.
(2) Install two bolts (7), washers (8), beveled washers (6), and lock
nuts (5). Do not tighten.
(3) Install four bolts (1), lockwashers (2), and washers (3) to secure two
intermediate bracket covers (4).
(4) Install remaining eight bolts (1), and lockwashers (2).
(5) Install bracket (11), lockwashers (10), and nut (9).
(6) Torque all hardware installed in accordance with Appendix G.
f .
Remove jackstands at rear of trailer.
h.
Refer to LO 10-4320-343-12 and add oil as necessary.
5-33
|