| |
TM 10-4320-343-14
5.5.7 Injection Nozzle Maintenance.
This task covers:
5.5.7.1 Removal
5 .5 . 7 . 3 I n s t a l l a t i o n
5 .5 . 7 . 2 R e p a ir
INITIAL SETUP
Tools
General Instructions
General Mechanics Tool Kit (appendix B,
To prevent rolling or sliding, do
Section III, Item 1)
not work on equipment that is not
securely stabilized.
Injector Pump Tester gauge (appendix B,
Section III, Item 9)
Do not smoke or use open flames
around fuel.
Ensure container is
Equipment Conditions
used to catch fuel and fuel is
disposed of properly.
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
Do not work on equipment without
following standard shop safety
Injection nozzle removed,
precautions.
paragraph 5.5.3 step a.
Figure 5-7.
Injection Nozzle Maintenance.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Do not smoke or use open flames around fuel.
Ensure container is used to
catch fuel and fuel is disposed of
Failure to obey these warnings may
5.5.7.1 Removal.
a .
Unscrew cap (figure 5-7, 1) and remove
p i e c e ( 4 ) .
properly.
result in personal injury or death.
body (2), needle (3), and intermediate
5-21
|