|
| |
TM 10-4320-343-14
4.17.5.1 Removal.
Failure to obey these warnings may result in personal injury or death.
To prevent rolling or sliding, do not work on equipment that is not
s e c u r e l y s t a b i l i z e d .
Ensure both wheels are secure.
Do not lift heavy assemblies without lifting device.
a .
S t a b i l i z e t r a i l e r .
b.
Using jack, carefully tilt entire assembly until enough clearance is attained
to remove support leg (figure 4-70, 1).
c .
Position two jack stands directly behind support leg housing.
Remove jack.
d .
Remove retaining pin (2).
e .
While holding support leg (1), remove anchor pin (3).
f .
Remove support leg (1).
4.17.5.2 Installation.
a.
Position support legs (1), align anchor pin holes, insert anchor pins (3).
b .
Install retaining pins (2).
c .
Using jack, raise until jack stands can be removed.
d.
Remove jackstands.
e .
Lower assembly until support legs (1) are fully down.
Remove jack.
4-132
|
