|
| |
TM 10-4320-343-14
4.14.6.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
s e c u r e l y s t a b i l i z e d.
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personnel injury.
a .
Loosen socket head screw (figure 4-59,
1) in actuator lever (2).
b .
Remove lock nut (3), bolt (4), and actuator lever (2).
c .
Remove lock nut (5), bolt (6), washer (7), spacer (8), and actuating rod (9)
from shutdown lever (10).
4.14.6.2 Installation.
a.
b.
c .
d.
e.
f .
NOTE
Ensure that equal number of threads are engaged
in each rod end to prevent thread
disengagement.
Loosen jam nuts (11) on actuating rod (9).
Rotate rod end to adjust length
to 4 3/8 inches (111 mm) from center of rod ends.
Tighten jam nuts (11).
Attach actuating rod (9) to center of shutdown lever (10) with bolt (6),
(head towards engine), washer (7) spacer (8), and locknut (5).
Manually rotate shutdown lever (10) up slightly from horizontal.
Install bolt (4) from engine side through outer hole in actuator lever (2)
and actuating rod (9) .
Secure with lock nut (3).
Tighten socket head screw (1).
4-111
|
