Order this information in Print

Order this information on CD-ROM

Download in PDF Format

     

Click here to make tpub.com your Home Page

Page Title: Control Box Maintenance. (Used on regulated models only)
Back | Up | Next

Click here for a printable version

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Combat
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
USMC
   
Products
  Educational CD-ROM's
Printed Manuals
Downloadable Books
   

 

TM 10-4320-343-14 4.14.4  Control Box Maintenance.  (Used on regulated models only) This task covers:  4.14.4.1  Adjustments 4.14.4.2  Repair 4.14.3  Installation INITIAL SETUP Tools General Mechanic's Tool Kit, (appendix B Section III, Item 1) 32 mm socket (appendix B, Item 25) Materials/Parts Lockwashers (TM 10-4320-343-24P) Equipment Conditions Equipment shut down, refer to paragraph 2.5.2.2 General Safety Instructions To prevent rolling or sliding, do not work on equipment that is not securely stabilized. Do not work on equipment without following standard shop safety precautions. 4.14.4.1.  Adjust. WARNING To   prevent   rolling   or   sliding,   do   not   work   on   equipment   that   is   not   securely stabilized.  Ensure both wheels are secure.  Failure to obey this warning may result in serious personnel injury. NOTE Adjustment   must   be   made   with   pump   suction   port   connected   to   a   source   of positive  pressure  of  10  psi  or  greater.    This  requirement  can  be  fulfilled  by  using another pump as suction pump, ahead of the pump to be adjusted. a. Remove four screws (Figure 4-55,1) and washers (2). b. Remove cover (3) from control box (4). c. Refer to figure 4-56 and set potentiometer as indicated below: A = 3 o'clock I = 8 o'clock GAIN = 9 o'clock L = Factory Set - Do not adjust D = 10 o'clock Droop = Fully Counterclockwise d. Refer  to  paragraph  2.5,  start  pump  and  immediately  after  engine  has  started  open  suction  and  discharge  hoses  of lines connected to suction or discharge manifolds. e. Allow engine to warm up at idle for two minutes, then place mode selector to MANUAL position. Change 1  4-103

Privacy Statement - Press Release - Copyright Information. - Contact Us - Support Integrated Publishing

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business