| |
TM 10-4320-343-14
4.14.3 Magnetic Pickup Maintenance.
This task covers: 4.14.3.1 Removal
4 .
14 . 3 . 3 I n s t a l l a t i on
INITIAL SETUP
Tools
General Safety Instructions
General Mechanics Tool Kit (appendix B,
To prevent rolling or sliding, do not
Section III, Item 1)
work on equipment that is not securely
s t a b i l i z e d.
Equipment Conditions
Do not work on equipment without
following standard shop safety
Equipment shut down, refer to
precautions.
paragraph 2.5.1.2 or 2.5.2.2.
4.14.3.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
s e c u r e l y s t a b i l i z e d.
Ensure both wheels are secure.
Do not work on pressure controller with negative terminal connected.
Failure to obey this warning may result in serious personnel injury.
a.
Disconnect electrical connector (figure 4-54, 1).
b.
Loosen jam nut (2) and remove magnetic pickup (3).
4.14.3.2 Installation.
a.
b.
c .
d.
e .
With a flashlight, look through threaded hole in flywheel housing.
Rotate engine crankshaft until a flywheel ring gear tooth centers threaded
h o l e.
Gently turn the magnetic pickup (3) into the hole until it bottoms against the
t o o t h.
Back off the magnetic pickup (3) 1/4 turn, then firmly tighten jam nut (2).
Connect electrical connector (1).
4-101
|