|
| |
TM 10-4320-343-14
4.13.3 Emergency Stop Switch (S1) Replacement.
This task covers: 4.13.3.1 Removal
4.13.3.2 Installation
INITIAL SETUP
Tools
General Mechanic's Tool Kit, (appendix B
Section III, Item 1)
Materials/Parts
Tags (appendix E, Section II, Item 12)
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2. or 2.5.2.2
Equipment Conditions (continued)
Control Panel Cover removed
paragraph 4.13.1.
General Safety Instructions
To prevent rolling or sliding, do not work on equipment
that is not securely stabilized.
Do not work on equipment without following standard
shop safety precautions.
Figure 4-43. Emergency Stop Switch 81 Removal and Installation.
4.13.3.1 Removal.
WARNING
·
To prevent rolling or sliding, do not work on equipment that is not securely
stabilized. Ensure both wheels are secure.
·
Disconnect negative cables from batteries.
·
Failure to obey these warnings may result in serious personal injury.
a.
Disconnect negative battery cable.
b.
Tag and disconnect wires (figure 4-43, 1) from switch (2).
c.
Unscrew knob (3) from shaft.
d.
Remove nut (4) from switch (2).
e.
Remove switch (2) from control panel.
4.13.3.2 Installation.
a.
Install switch (2) into control panel.
4-84
|
