|
| |
TM 10-4320-343-14
4.12.5.2 Wiring Harness Maintenance. (Not used on Model 350 PAFN)
This task covers: 4.12.5.2.1 Removal
4.12.5.2.2 Repair
4.12.5.2.3 Installation
INITIAL SETUP
Tools
Equipment Conditions (continued)
General Mechanic's Tool Kit (appendix B,
Equipment shut down, refer to paragraph 2.5.2.2
Section III, Item 1)
Battery cover removed, paragraph 3.4.
Battery disconnected, paragraph 4.12.2.
Material/Parts
Lockwashers (TM 10-4320-343-24P)
V-belt guard removed, paragraph 4.10.6.
Washers (TM 10-4320-343-24P)
Tags (appendix E, Section II, Item 12)
General Safety Instructions
To prevent rolling or sliding, do not work on equipment
that is not securely stabilized.
Do not work on equipment without following standard
shop safety precautions.
4.12.5.2.1 Removal.
WARNING
Do not work on wiring harness with battery connected.
To prevent rolling or sliding, do not work on equipment that is not securely
stabilized. Ensure both wheels are secure.
Failure to obey these warnings may result in serious personnel injury.
a.
Disconnect and tag lines (Figure 4-39 sheet 1, view D, 1 and 2) from cold start reservoir.
b.
Remove screws (view C, 3), lockwashers (4), washers (5) and cold weather start kit (6).
c.
Remove four remaining screws (view A, 3) and lockwashers (4) that secure control panel cover (7).
d.
Remove control panel cover (7).
e.
Tag and disconnect the wiring harness as follows:
(1)
Wires connected to terminal board ( Figure 4-39, view B, 8).
Change 1 4-77
|
