|
| |
TM 10-4320-343-14
4.11.1 Removal.
To prevent rolling or sliding, do not work on equipment that is
not securely stabilized.
Ensure both wheels are secure.
Failure to obey this warning may result in serious personal
i n j u r y.
a.
Remove set screw (figure 4-35,
1), cotter pin (2), pin (3), and spacer (4).
b.
Remove knob (5) and throttle control assembly.
4.11.2 Disassembly.
a .
Squeeze ends of clamp (6) and remove bellows (7) .
b .
Loosen lock nut (8) and remove coupling nut (9), retaining spring (10), lock
nut (8), and clamp (6).
c .
Remove threaded rod (11), threaded rod (12), set screw (13), rod (14), and
extension rod (15).
4.11.3 Repair.
Units without bellows may have a longer extension rod and shorter coupling
nut than those units with bellows.
If replacement of either of these
parts is required,
they must be replaced as a set in order to obtain the
required length.
Replace any damaged or missing parts.
4.11.4 Assembly.
a .
Position rod (14) in extension rod (15) and secure with set screw (13).
b .
Install threaded
c .
Install threaded
of the way.
rod (12) on knob (5) .
rod (11) on hex end of extension rod approximately one third
Ensure locking nut is secure against coupling nut.
This adjusts
throttle control assembly to proper length.
d.
Install lock nut (8), retaining spring (10), clamp (6), coupling nut (9), and
bellows (7) .
e .
Squeeze end of clamp (6) and install on bellows (7) .
4.11.5
Installation.
a.
Install throttle control assembly through throttle bracket and install
knob (5).
b.
Install spacer (4) and pin (3) through coupling nut and control arm and
install cotter pin (2) through pin (3).
c .
Install set screw (1).
4-67
NOTE
NOTE
|
