|
| |
TM 10-4320-343-14
4.10.24.1 Removal.
WARNING
To prevent rolling or sliding, do not work on equipment that is not securely
stabilized. Ensure both wheels are secure. Failure to obey this warning may result
in serious personal injury.
a.
Tag and disconnect V-belt contact switch wires (figure 4-34, 1).
b.
Remove spacer (2).
c.
Hold pulley (3) and remove bolt (4) and contact switch bracket (5).
d.
Remove nut (6), washer (7), bolt (8), washer (9) and idler pulley assembly (10).
e.
Remove and discard preformed packing (11).
4.10.24.2 Installation.
a.
Install new preformed packing (11).
b.
Position idler pulley assembly (10) in place on engine and install washer (9), bolt (8), washer (7), and nut (6).
c.
Raise pulley (3) and install contact switch bracket (5) with bolt (4).
d.
Install spacer (2).
e.
Connect V-belt contact switch wires (1).
4-65
|
