|
| |
TM 10-4320-343-14
4.10.12 Alternator Maintenance.
This task covers:
4.10.12.1 Removal
4.10.12.2 Installation
INITIAL SETUP
Tools
General Mechanic’s Tool Kit (appendix B,
Section III, Item 1)
Material/Parts
Lockwashers (TM 10-4320-343-24P)
Washers (TM 10-4320-343-24P)
Tags (appendix E, Section II, Item 12)
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
Alternator V-belt removed
(paragraph 4.10.7).
General Safety Instructions
To prevent rolling or sliding, do not
work on equipment that is not securely
stabilized.
Do not work on equipment without
following standard shop safety
precautions.
4.10.12.1 Removal.
a.
b.
c.
d.
e.
4.10.7.2
a.
b.
c.
d.
e.
f .
•
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
•
Do not work on alternator with negative battery cable connected.
•
Failure to obey these warnings may result in serious personal injury.
Disconnect negative battery cable.
Tag and disconnect alternator quick disconnect lead (figure 4-16, 1).
Remove nut (2).
Tag and disconnect wire (3).
Remove nut (4) and lockwasher (5). Tag and disconnect wire (6).
Remove bolt (7), lockwasher (8), washer (9), bolt (10), lockwasher (11),
washer (12) and alternator (13) .
Installation.
Position alternator (13) in place on engine.
Install, but do not fully tighten, washer (12), lockwasher (11), bolt (10),
washer (9), lockwasher (8), and bolt (7).
Install
Install
Connect
Connect
wire (6), lockwasher (5) and nut (4).
Remove tag.
wire (3) and nut (2).
Remove tag.
alternator quick disconnect lead (1) .
Remove tag.
negative battery cable.
4-36
|
