|
| |
TM 10-4320-343-14
4.10.1.1 Removal.
WARNING
To prevent rolling or sliding, do not work on equipment that is not securely
stabilizes. Ensure both wheels are chocked.
Do not touch exhaust system after equipment operation. Exhaust systems
become very hot and can cause serious burns.
Failure to obey these warnings could result in serious injury.
a.
Remove five nuts (Figure 4-4, 1), one post (2) and six washers (3) that secure muffler (4) to engine.
Retain all parts removed.
b.
Carefully remove muffler (4) from studs.
c.
Remove and discard three gaskets (5).
4.10.1.2 Disassembly.
a.
Loosen nut (Figure 4-4, 6), lockwasher (7) and bolt (8) that secures clamp (9).
b.
Remove exhaust pipe (10) and clamp (9) from muffler (4).
4.10.1.3 Repair.
a.
Inspect muffler for holes and cracks.
b.
Check to ensure internal components are not burned out.
4.10.1.4 Reassembly.
a.
Position clamp (9) over the muffler (4) and position open end of exhaust pipe upward.
b.
Install exhaust pipe (10) into muffler (4) and position as shown.
c.
Tighten nut (6) until exhaust pipe (10) is secure.
4.10.1.5 Installation.
a.
Position three gaskets (5) over studs.
b.
Carefully install muffler (4) over studs with exhaust pipe.
c.
Install six lockwashers (3), five nuts (1) and one post (2) and tighten.
4-17
|
