|
| |
TM 10-4320-342-24
D-2. MANUFACTURED ITEMS PART NUMBER INDEX - continued.
1.
Fabricate tubing from MIL-T-8808, Type I, COMP 347, CRES, .312 OD x .035 Wall.
2.
Cut and bend tubing as illustrated above.
NOTES
· To prevent the tubing being too short, figure out the total length required before
cutting the tubing and add 6 inches. This will allow for the required bends in the
tubing.
· Dimensions are for general routing and may be altered to facilitate installation.
3.
Install nut, part number AN818-5J and sleeve, part number MS20819-5J on ends of tubing.
4.
Flare both ends of tubing.
Figure D-28. Tube Assembly, P/N 13229E3993
D-31
|
